CharterOak Acoustic Devices
CharterOak SA538 - Vacuum Tube Condenser
Frequency Response 30Hz-20Khz,
Maximum SPL 128db,
Sensitivity 12mV/Pa 0db=1V/Pa@1Khz,
E.I.N. 22db A weighted,
Polar Pattern is variable.
CharterOak SA538B - Side Terminated Dual Diaphragm
Vacuum Tube Condenser Mic for extended & flat bass frequency
Frequency Response 25Hz-20khz,
Maximum SPL 128db,
Sensitivity 12mV/Pa 0db=1V/Pa@1khz,
E.I.N. 22db A weighted,
Polar Pattern is variable.
CharterOak E700 - Solid State Condenser Mic
Frequency Response 25Hz-20khz,
Maximum SPL 125db,
Sensitivity 16mV/Pa 94dB=1V/Pa@1kHz,
E.I.N. 17dB A weighted IEC651,
Polar Pattern Cardioid, Omni, Figure-8
CharterOak M900 - Small Diaphragm Condenser
Frequency Response 30Hz-20khz,
Maximum SPL 137db,
Sensitivity 10mV/Pa (1kHz@74dB S.P.L),
E.I.N. 18dB A weighted IEC651,
Polar Pattern Cardioid, Hyper Cardioid, Omni
CharterOak M900-T - Small Diaphragm Tube Condenser
Frequency Response 25Hz-20khz,
Maximum SPL 138db,
Sensitivity -34dB (0dB=1V/PA),
Polar Pattern Cardioid, Hyper Cardioid, Omni
CharterOak S700 - Broadcast Microphone
Frequency Response 20Hz-20khz,
Maximum SPL 125db,
Sensitivity 16mV/Pa 94dB=1V/Pa@1kHz
Pattern: Cardioid
Grimm Audio MP1
In any audio device, the power supply is a significant contributor to sonic success or failure. In tube microphones this is even more so than anywhere else. The MP1 allows you to realise the full potential of your treasured vintage or contemporary tube mic.
The 'MP1 | Grimm' re-writes the book on tube mic supplies. Drawing from the extensive expertise gained designing the supplies used in the AD1 and CC1 products, the MP1 uses discrete shunt regulators both in the anode supply as well as the filament supply. The anode supply offers noise as low as -100 dBV (in average 20 dB beter than existing supplies) and the 'shunt' design turns the regulator into an active decoupling device, eliminating electrolytics. Voltages are factory pre-set to match the customer's microphone specs.
Stylish, compact and practical, the MP1 fits well on any recording stage.
New Sontronics Matrix 10
The Matrix10 is a professional mobile microphone stand made from brushed aluminium tubing and has the ability to support up to 6 kilograms.
Its sturdy central post extends by way of quick-release/quick-lock clips to 1.7 metres and is internally damped to support heavy loads. Its telescopic boom arm, attached to the main stand with a heavy-duty ABS clamp extends from 1.2 metres to 2.25 metres and is counterbalanced by a moveable cast-iron weight.
The Matrix10 comes with a separate dolly cart that transforms it into a mobile stand.
The dolly can be fitted to the tripod in seconds thanks to its simple adjusting clamps, adding 10cm to the overall height of the stand. Each wheel has a foot-operated brake to provide optimum stability. When not in use, the wheels fold up to be stored in the rugged canvas bag.
Tech specs
* Overall height: 1.12 metres, extendable to 1.7 metres
* Telescopic boom arm: 1.2 metres, extendable to 2.25 metres
* Accessories: Removable three+wheel dolly with canvas bag
Promo € 184 excl VAT (€ 222,64 incl VAT)